![]() New for October 2013: we describe egg crate construction. In the abstract he describes it as "a new member of the class of aperiodic continuously scaled antenna structures, as such, it has theoretically unlimited instantaneous bandwidth." Gibson in a paper entitled The Vivaldi Aerial. The Vivaldi antenna was first discussed in a 1979 IEEE European Microwave Conference paper by P. Peter Gibson invented the Vivaldi antenna in 1978, in the UK. The Vivaldi antenna, sometimes referred to as or the Vivaldi notch antenna, and also known as the tapered slot antenna (TSA), is easy to fabricate on a circuit board, and can provide ultra-wide wide bandwidth. Finally, the performance of the Vivaldi antenna has been validated by FEKO and HFSS software, and we achieved a very good matching among the results.Click here to go to our main page on antennas The antenna is designed, simulated, and analyzed by using computer simulation technology microwave studio (CST-MWS). ![]() Thus, after design, optimization, and simulation, the antenna produces a good reflection coefficient over the very large operating bandwidth of 23.19 GHz, 1 < VSWR < 2, maximum gain of 10.2 dBi, and average radiation efficiency of above 90%, which can be recommended as a suitable antenna for lower 5G as well as satellite applications. The proposed antenna incorporates a simple structure and small size with dimensions of 45 × 35 × 0.79 mm3. At the edge of wireless communication, we want to enhance two key aspects within the communication systems: the quality of service and the cost. Ten corrugated side slots, two circular slots, and one via have been used to enhance the performance especially bandwidth and gain of the antenna. All dimensions of those slots were chosen by using the sweep parameter method. In the presented Vivaldi antenna, different slots are applied not only to increase the gain and directivity but also to get operating frequency at the intended specific frequency range. In this paper, a super wide band (SWB) Vivaldi antenna has been proposed for lower 5G bands in Sub-6 GHz and satellite applications (S, C, X, Ku, and K band) using various performance improvement techniques. ![]() All these results suggest that the antenna is suitable for microwave imaging applications. The constructed antenna has a lower bandwidth than the simulated one, with operating frequencies of 3.5 GHz – 3.75 GHz and 4.25 – 10.89 GHz, respectively, and useable bandwidths of 250 MHz and 6.64 GHz. The increase in gain is proportional to the frequency of operation. In comparison to a typical single slot antenna, the suggested antenna provides a substantial boost in gain performance. Based on the modeling findings, the suggested antenna attain a bandwidth of 7.5 GHz with operating frequencies from 3.1 GHz to 10.6 GHz for a VSWR of less than two. ![]() The antenna is designed to operate at frequencies ranging from 3.1 to 10.6 GHz. The proposed Vivaldi antenna is designed using a double-slot structure method with the addition of corrugated edges and a semicircle director aimed at improving the gain. In this work, we present a high-gain Vivaldi antenna for microwave imaging applications. The antenna is utilized because of its simple, lightweight, and compact design, as well as its excellent efficiency and gain capabilities. The Vivaldi antenna is one of the most popular antennas for this purpose. Microwave imaging, such as images for radiological inspection in the medical profession, is one of the applications utilized in ultra-wideband (UWB) frequency ranges. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |